Repair Kit for ECOVENT - Thermoelectric Module and Motor

Repair Kit for Ecovent Stove Fans and Chimneys

This kit is suitable for most fans from our range. The kit includes:

Thermoelectric Module

with dimensions of 4x4 cm. The thermoelectric module is compatible with all fans except Ekovent Rotating, Ekovent Stove, and Ekovent Blower.

Motor

using carbon brushes, increasing its lifespan and, above all, its performance. The motor is compatible with all fans except Ekovent Rotating, Ekovent Stove, and Ekovent Blower.

The motor is secured into two opposing holes, positioned at the outermost edges.

The motor and thermoelectric module connectors are compatible with each other. If your connector is not identical, it is necessary to replace both parts at once.

During assembly, correct polarity must be maintained. The red wire of the thermoelectric module must be on the same side as the original. Otherwise, the fan will rotate in the opposite direction.

Before purchasing, check if the screw hole spacing in the motor is compatible with the motor holder. If not, adjust the holder to the specified screw hole spacing.

The kit is not compatible with Ekovent: 85-320°C Rotating, Duo, Stove, Blower.

Parameters:

Thermoelectric Module

Dimensions of the thermoelectric module: 4x4x0.4 cm

Length of the thermoelectric module cable: 5.3 cm

Maximum temperature of the thermoelectric module: 345°C

Motor

Motor diameter: 2.4 cm

Motor shaft length: 1.2 cm

Spacing of holes for screw attachment: 1.73 cm

Diameter of holes for screw attachment: 0.28 cm

Length of the motor cable: 6.2 cm

Diameter of the flange on the base of the shaft: 0.65 cm

Shaft diameter: 0.2 cm

Connector

Male width: 0.66 cm

Female width: 0.8 cm

Packaging:

1 x thermoelectric module

1 x motor