EKOVENT ROUND 4 flue fan

EKOVENT ROUND 4 for flue pipe

The fan is attached to the flue pipe of the fireplace stove with two steel pull-tabs. The tapes are designed for a diameter of 141 -165 mm. In case of larger flue diameters, it is possible to buy the pulling strips at any hardware store. This fan is also suitable for those stoves that do not allow the fan to be placed on a hot top due to the roundness of the top, or for multi-burner stoves that do not reach sufficient surface temperature for the highest fan output.

The fan provides and maintains horizontal air circulation.
Instead of warm air rising naturally to the ceiling and cold air accumulating near the floor, i.e. near you, there is a more even distribution of comfortable heat throughout the room.

In doing so, it does not need any external source of electricity, as it generates its own electricity for its operation using the heat from the stove.

This fan is capable of operating even at low temperatures. Its initial starting temperature is 80°C which is equivalent to about 120°C measured at the flue.
The fan´s propeller starts spinning shortly after the room is flooded, which speeds up the heating of the entire room and can raise the temperature on the other side
by several degrees.

The fan can change up to 380 m3 of air per hour, saving up to 18% fuel.

Main technological advantages:

1) The functional design of the
fan is based on the latest theories and laws of aerodynamics. We work directly with the manufacturer to develop the fan.

2) The duralumin body of the
fanconducts heat very well, which is the basis for the efficiency and performance of the fan. The bottom base is wide to maximize heat transfer.
The cooling fins are located at the top to cool the top of the thermoelectric module. Since the performance of the thermoelectric module
is based on the temperature difference between its top and bottom sides, the design of the fan body is critical.

3) The highly efficient thermoelectric module
has been adapted to the design and parameters of the whole fan at our request directly from the peltier cell manufacturer.
As a result, its performance matches the energy requirements of the electric motor and the propeller resistance, and high efficiency
has been achieved, surpassing other thermoelectric modules on the market.

4) The motor
that is commonly used for these fans has a commutator with copper brushes.
Our motor uses carbon ones and thanks to this its lifetime and especially its performance are maximized.

5) The design of the propeller blades
is designed and manufactured exactly according to the laws of aerodynamics
and the fan is thus able to convert all the energy produced
into airflow without unnecessary losses.

6) Smoke duct mounting
Included in the package are two drawbands for smoke ducts up to 160 mm in diameter. If the tapes do not fit the diameter of your flue they can be replaced with steel tapes in the diameter you require. They are readily available from hardware stores.

- saves up to 18% of fuel
- maximum working temperature 80°C - 340°C
- ideal working temperature 90°C - 340°C
- generates its own electricity by using the heat from the stove
- the fan exchanges up to 380 m3/hr, helping to circulate warm air in the room
- the fan changes speed automatically, depending on the flue temperature. The higher the temperature, the faster the propeller spins.
- completely silent operation

Dimensions: 25cm * 18cm * 11,5cm
Weight: 830g
Propeller: black, 4 blades

Package:
1 x EKOVENT eco-friendly fan for flue
2 x steel tightening tape
1 x instruction manual